Operation Manual

Connection and starting 30

The following table shall give a rough orientation for the adjustment of subwoofer crossover

frequency.

Loudspeaker set up Crossover adj. at ELAC subwoofer

Surround system with LFE-Channel 180 Hz

Audio system with miniature speakers 180 Hz

ELAC 301, Starlet;

all Cinema 2, 1, 07, 05 components

120 Hz

HiFi-system with small bookshelf speakers 120 Hz

HiFi-system with full range speakers

60 Hz

10 LED for Bluetooth® activity

This signals the working status of the Bluetooth® receiver. After selection

of POWER mode to “ON” (see pt. 6) the LED will twinkle for 1 second,

indicating the start up of the receiver module. If there is no Bluetooth®

source actively connected to the receiver the LED will flash up shortly

once every 7 seconds (= BT stand-by). If a Bluetooth® source is connecting to the receiver

the LED will light permanently until the audio transmission begins (= BT waiting).

During normal Bluetooth® audio transmission the LED will flash up with a 1 second cycle.

Again the twinkle sequences are shown graphically as follows.

Note:

The following chapter explains the Bluetooth® wireless technology in more detail.

Please read carefully because some special features of this transmission standard and its

protocol (A2DP) are mentioned.

permanent

seconds

permanent

seconds

Start of the Bluetooth

receiver module

Bluetooth

active, but no connection

Bluetooth

not activated

Bluetooth

active and connected, no audio transmission

Bluetooth

active, connected, audio transmission working

seconds