Quick Install Guide

QUICK INSTALL GUIDE
2
IMPORTANT SAFETY INSTRUCTIONS
1. Read, understand and follow ALL safety and installation instructions included in this
manual. Failure to follow the included documentation may damage the product and will void
manufacturer’s warranty.
2. Follow ALL installation guidelines included with the product. Installation of the product in high
humidity environments, in close proximity to heat sources and /or non-recommended locations
will impede, interfere and/or damage the intended operation of the product.
3. Only use attachments and accessories which have been specified for use by the manufacturer.
4. The use of abrasive, liquid or solvent based cleaning fluids will damage the product. Please refer
and follow all Product Care instructions included with the product.
5. Product Servicing may only be completed by authorized or certified service centers & personnel.
For a complete list of product servicing options, please follow instructions included in the
product documentation and /or contact original manufacturer for details.
FCC and IC Information:
This Class B digital apparatus complies with Part 15 of the FCC rules and with Canadian ICES-003 and
RSS-247.
RESTRICTIONS IN THE 5 GHZ BAND: Within the 5.15 to 5.25 GHz band, UNII devices will be restricted to
indoor operations.
Operation is subject to the following two conditions:
1. This device may not cause interference and
2. This device must accept any interference, including interference that may cause undesired
operation of the device.
Cet appareil numérique de classe B est conforme aux normes canadiennes ICES-003 et RSS-247.
RESTRICTIONS DANS LA BANDE DE 5 GHZ: Dans la bande de 5,15 à 5,25 GHz, les appareils UNII seront
restreints aux opérations.
Son fonctionnement est soumis aux deux conditions suivantes : (1) cet appareil ne doit pas causer
d’interférence et (2) cet appareil doit accepter toute interférence, notamment les interférences qui peuvent
affecter son fonctionnement.
Warning:
Changes or modications to this unit not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
FCC and IC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and
meets the exemption from the routine evaluation limits in section 2.5 of RSS 102.
1. This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
2. This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of 20
centimeters from user and bystanders.
Warning:
The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102, and users
can obtain Canadian information on RF exposure and compliance from the Canadian Representative Nortek
Control at Tel: [phone].
To maintain compliance, only the antenna types that have been tested shall be used.
This radio transmitter [IC: 1078A-00211] has been approved by Innovation, Science and Economic
Development Canada to operate with the antenna types listed below, with the maximum permissible gain
indicated. Antenna types not included in this list that have a gain greater than the maximum gain indicated
for any type listed are strictly prohibited for use with this device.