LED 2-RING PENDANT MODEL #83088 Français p. 10 ATTACH YOUR RECEIPT HERE Serial Number Purchase Date Questions, problems, missing parts? Before returning to your retailer, call our customer service department at 1-855-226-7169, 8 a.m. - 4 p.m., EST, Monday - Friday.
PACKAGE CONTENTS A G F H I C B E D PART A B C D E F G H I DESCRIPTION Canopy Small LED Ring Canopy Arm Mounting Screw Large LED Ring Set Screw Compression Fitting Cable Cord 2 QUANTITY 1 1 1 2 1 1 1 1 1
HARDWARE CONTENTS AA BB CC DD EE Ground Screw Qty: 1 Wire Short Connector Machine Anchor Screw Qty: 3 Qty: 2 Qty: 2 FF GG HH Allen Tool Anchor Screw Qty: 2 Mounting Bracket Qty: 1 Threaded Knob Qty: 2 Qty: 1 SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble, operate or install the product. • • • • • • WARNING IMPORTANT: NEVER attempt any work without shutting off the electricity. Go to the main fuse box, or circuit breaker, in your home.
CAUTION CAUTION • Read and understand all instructions and illustrations completely before proceeding with assembly and installation of this fixture. • If you have any doubts about how to install this lighting fixture, or if the fixture fails to operate completely, please contact a qualified licensed electrical contractor. • All parts must be used as indicated in these instructions. Do not substitute any parts, leave parts out, or use any parts that are worn out or broken.
ASSEMBLY INSTRUCTIONS 2. Temporarily raise mounting bracket (DD) to ceiling. Mark location for anchor (CC). Use 9/32 size drill to drill holes for anchor (CC). Insert anchor (CC) into hole. 2 Ceiling CC Hardware Used CC Anchor x2 DD 3. Connect the mounting bracket (DD) to the outlet box with short machine screws (BB). 3 Outlet Box (Not Included) Hardware Used Short Machine BB Screw x2 BB x1 DD Mounting Bracket 4. Screw anchor screws (HH) through mounting bracket (DD) and into anchors (CC).
ASSEMBLY INSTRUCTIONS 5. Wire connection guide: 5 Ground wire: • For installation in the United States: Wrap ground wire from outlet box around ground screw (EE) on mounting bracket (DD) no less than 2 in. from wire end. Tighten ground screw (EE). If fixture is supplied with a ground wire, connect to outlet ground wire with a wire connector (AA). • For installation in Canada: If fixture is supplied with ground wire, wrap ground wire around ground screw (EE) on mounting bracket (DD).
ASSEMBLY INSTRUCTIONS 6. Pass canopy (A) over the mounting bracket (DD) and secure with the threaded knobs (FF). 6 DD A Hardware Used Threaded FF Knob x2 FF 7. Raise small LED ring (B) to canopy arm (C). Connect wire from the LED ring (B) to wire from the canopy arm (C). Repeat this step for the large LED ring (E). 7 B C 8. Screw in the mounting screw (D) using the allen tool (GG) to secure the small LED ring (B) and large LED ring (E) to the canopy arm (C).
CARE AND MAINTENANCE • Always be certain that electric current is turned off before cleaning this item. • Use a soft, moist cloth with mild non-abrasive soap to clean fixture. Never use glass cleaner on fixture, as it will damage the metal finish. • All glass shades may be washed in a towel-lined sink with warm water and mild soap. Do not wash shades in an automatic dishwasher. TROUBLESHOOTING PROBLEM Fixture does not light. POSSIBLE CAUSE CORRECTIVE ACTION Fixture may be wired incorrectly.
REPLACEMENT PARTS LIST For replacement parts, call our customer service department at 1-855-226-7169, 8 a.m. - 4 p.m., EST, Monday - Friday. PART AA BB CC DD FF GG HH DESCRIPTION Wire Connectors Short Machine Screw Anchor Mounting Bracket Threaded Knob Allen Tool Anchor Screw AA BB FF Rev.
LUMINAIRE SUSPENDU À 2 ANNEAUX À DEL MODÈLE #83088 JOIGNEZ VOTRE REÇU ICI Numéro de série Date d’achat Des questions, des problèmes, des pièces manquantes? Avant de retourner l’article au détaillant, appelez notre service à la clientèle au 1 855 226-7169, entre 8 h et 16 h (HNE), du lundi au vendredi.
CONTENU DE L’EMBALLAGE A G F H I C B E D PIÈCE A B C D E F G H I DESCRIPTION Pavillon Petit anneau à DEL Bras du pavillon Vis de montage Grand anneau à DEL Vis de réglage Raccord à compression Câble Cordon 11 QUANTITÉ 1 1 1 2 1 1 1 1 1
QUINCAILLERIE INCLUSE AA BB DD CC Capuchon Vis à de connexion métaux Qté : 3 Pièce courtes d’ancrage Qté : 2 Qté : 2 FF GG EE Vis de mise à la terre Qté : 1 Support de fixation Qté : 1 HH Boutons filetés Qté : 2 Clé Allen Qté : 1 Vis à pièce d’ancrage Qté : 2 CONSIGNES DE SÉCURITÉ Veuillez vous assurer de lire et de comprendre l’intégralité du présent guide avant d’assembler, d’utiliser ou d’installer ce produit.
MISE EN GARDE • • • • • • • • Prenez soin de lire et de comprendre toutes les instructions et illustrations avant de commencer l’assemblage et l’installation de ce luminaire. Si vous avez des doutes à propos de l’installation, ou si le luminaire ne fonctionne pas correctement, veuillez communiquer avec un électricien qualifié. Toutes les pièces doivent être utilisées tel qu’il est indiqué dans ces instructions.
INSTRUCTIONS POUR L'ASSEMBLAGE 2. Placez temporairement le support de fixation (DD) au plafond. Marquez l'emplacement des ancrages (CC). Utilisez une perceuse équipée d'un foret de 9/32 po afin de percer les trous pour les ancrages (CC). Insérez les ancrages (CC) dans les trous. 2 Plafond CC Quincaillerie utilisée CC Pièce d’ancrage x2 DD 3. Fixez le support de fixation (DD) à la boîte de sortie à l'aide des vis à métaux courtes (BB).
INSTRUCTIONS POUR L'ASSEMBLAGE 5. Guide de raccordement électrique 5 Fil de mise à la terre : • Pour une installation aux États-Unis : enroulez le fil de mise à la terre provenant de la boîte de sortie autour de la vis de mise à la terre (EE) située sur le support de fixation (DD), à au moins 5 cm (2 po) de l’extrémité du fil. Serrez la vis de mise à la terre (EE).
INSTRUCTIONS POUR L'ASSEMBLAGE 6. Faites passer le pavillon (A) sur le support de fixation (DD) et fixez à l'aide des boutons filetés (FF). 6 DD A Quincaillerie utilisée Boutons FF filetés x2 FF 7. Placez le petit anneau à DEL (B) sur le bras du pavillon (C). Connectez le fil de l'anneau à DEL (B) au fil du bras du pavillon (C). Répétez cette étape pour le grand anneau à DEL (E). 7 B C 8.
ENTRETIEN • Vérifiez toujours que le courant est coupé avant de nettoyer le luminaire. • Utilisez un linge doux et humide ainsi qu’un savon non abrasif. N’utilisez jamais de nettoyants pour vitres; vous risqueriez d’endommager le fini métallique du luminaire. • Les abat-jour en verre peuvent être nettoyés dans un évier couvert de serviettes, à l’aide d’eau tiède et de savon doux. Ne nettoyez pas les abat-jour dans un lave-vaisselle. DÉPANNAGE PROBLÈME Le luminaire ne s’allume pas.
LISTE DES PIÈCES DE RECHANGE Pour obtenir des pièces de rechange, appelez notre service à la clientèle au 1 855 226-7169, entre 8 h et 16 h (HNE), du lundi au vendredi. PIÈCE AA BB CC DD FF GG HH AA BB FF Rev.