Installation manual

E L A N H O M E S Y S T E M S
Page 20 © ELAN Home Systems 2009 • All rights reserved.
A6 INSTALLATION MANUAL
CHANNEL BRIDGE MODE Setting
The Channel Bridging buttons for the A6 are located on the back panel next to the Line Outputs. These recessed
buttons are located beneath a decal. Using a small Phillips screwdriver carefully pierce the decal to access the but-
ton. The buttons are Factory Defaulted in the OUT (OFF) position. Audio signals connected to the # 1 & 3 & 5 chan-
nels of the A6's LINE INPUT will be routed to the top row of speaker outputs. See Figure 2-9: 3 Channel Bridged for
more details.
• Channel 1 & 2 Positive (+) Binding Post terminals become the bridged Output of Channel 1.
• Channel 3 & 4 Positive (+) Binding Post terminals become the bridged Output of Channel 3.
• Channel 5 & 6 Positive (+) Binding Post terminals become the bridged Output of Channel 5.
+
1 + 2 3 + 4 5 + 6
Speaker
Binding
Post
Positive
Terminals
Speakers
8 Ohm
Minimum
Bridge
Mode
Buttons
Figure 4-3: A6 Channel Bridge Mode Buttons