Elan A6 : Installation manual : Page 33

E L A N H O M E S Y S T E M S

A6 INSTALLATION MANUAL

Appendix B: Rack Mounting

Rack-Mount Brackets

When mounting the A6 amplifier in an equipment rack, use the included rack mount brackets for secure mounting

and proper ventilation. The A6 requires one rack space, ensure that one rack space above and below the A6 is left

open for proper ventilation. To install the A6 into a standard 19” equipment rack:

1. Slide the rack mount kit onto the A6 chassis from the front as shown in Figure B-1.

Figure B-1

2. Ensure that the unit is flush with the front of the mounting kit. Install each of the eight screws (included) through

the side mounting flanges into the holes in the sides of the unit as shown in Figure B-2. Hand tighten screws!

Over-tightening could cause damage to the A6 Amplifier.

Figure B-2

3. Once the unit is securely mounted onto the rack mount brackets, install the entire assembly into a standard 19”

equipment rack from the front using four rack screws (not included) as shown in Figure B-3.

19" Equipment Rack

Rack Screws

Figure B-3