Specifications

complete
82
©2004 ELAN HOME SYSTEMS • Lexington, KY USA • All Rights Reserved.
ACCESSORIES
LSWP SYSTEM12 LOCAL SOURCE
WALL PLATE KIT
FEATURES & SPECS
SPECIFICATIONS:
Input Level: ..............................0 – 2V RMS
Gain: ........................+1dB at Source plate,
-1dB at S12, 0dB total
Frequency Response: ........20Hz to 20kHz,
+/-0.5dB
THD + Noise: ..................................<0.01%
IR Output Level: ..................................+12V
IR Bandwidth:..................................100kHz
Wire Requirements:
(Audio/IR)........................................Cat-5
(Video) ....................................RG-6 Coax
Style: ..........................White Decora
®
only
Designed for use with the System12’s eight
Local Source Inputs, the LSWP sends audio
from any local source (i.e. a CD player in
the Master Bedroom) back down to the
S12, and IR control signals from the S12
back to the local source.
Audio and IR are transmitted over a single
run of Cat-5 cable to the local source RJ-45
jacks on the S12. Balanced differential line
drivers ensure noise-free audio from
sources located up to 300 feet from the
S12. An IR OUT jack on the wall plate
allows you to plug in an IR emitter
(included) for control of the source from
that zone’s keypad or touch panel.
Up to eight Local Source Wall Plates,
one for each zone, can be connected to
an S12. Systems with more than one S12
(and you can link up to four of them!)
can accommodate eight LSWPs per S12.
Kit includes:
(1) Local Source Wall Plate
(1) IR Emitter
(1) 1-Meter Stereo Interconnect Cable
(1) Leviton
®
Frame
PBKT6P PRECISION PANEL ROUGH-IN BRACKETS
FEATURES & SPECS
20-gauge steel frame
Router-friendly
For use with PS12, PZ6, PHD12,
PVIA10, PSP12, PMP6 Precision Panels
and PF2 Precision Panel Frame
Available in packages of 6
The rough-in bracket for all full-sized
Precision Panels, the PBKT6P looks a lot
like a speaker rough-in bracket because it
once was. A sliding frame on metal straps
adjusts to any location between the studs,
ensuring perfect alignment.
PF2 PRECISION PANEL FRAME
FEATURES & SPECS
Frame and insert for installing
two ‘1/2-frame’ Precision Panels
Blank ‘1/2-frame’ plate and mounting
screws included
PBKT6P Rough-In Brackets available
in packages of 6
The PF2 is required for the installation
of all ‘1/2-frame’ Precision Panels
Dimensions:
Wall Cutout ....................8" W x 10-1/2" H
204mm W x 267mm H
Installed with frame ......9-3/4" W x 12" H
248mm W x 305mm H
The PF2 accommodates any two of the new
‘1/2-frame’ Precision Panels (PZ600, PVSE,
PV12, PSP6). The kit includes a full-size
Precision Panel frame, an insert with
pre-drilled holes for the mounting of two
‘1/2-frame’ Precision Panels, mounting
screw, and a blank ‘1/2-frame’ plate to
cover any unused half of the frame.
New-construction brackets are available,
or the PF2 can easily be retro-fitted using the
four clamping legs attached to the frame,
which clamp the panel securely to drywall.
The PF2 is required for the installation of
all ‘1/2-frame’ Precision Panels.
Ac_FINAL.qxd 1/24/05 5:01 PM Page 82