Specifications

IR Systems
©2009 ELAN HOME SYSTEMS • LEXINGTON, KY • ALL RIGHTS RESERVED
80
IR Systems
The IRIC is a 3.5 mm mono “mini”plug
interconnect cable that is used for IR connections
between ELAN multi-room controller IR output
ports and any source that has a 3.5 mm IR input
jack. Also perfect for routing the trigger outputs of
ELAN multi-room controllers to ELAN amplifiers,
Z•Fans and the Z•Power Controller.
FEATURES
Plug-and-play cable for direct IR jack
connections between components
3.5 mm plug-to-3.5 mm plug, 2 m length
Available in pkgs. of 6
Not for use with the IRD4 Amplified
Distribution Block
Non-retail packaging
IRIC IR INTERCONNECT CABLE
Designed specifically to allow you to control one
source from two independent IR outputs, the
IRYC is a one foot long “Y” cable that converts
any ELAN IR Emitter into a dual-plug IR emitter.
Internal diodes built into the IRYC prevent
conflicts between IR outputs.
IRYC IR EMITTER “Y” CABLE
FEATURES
1-foot “Y” cable for dual-plug / single-emitter
applications
Internal diode protection
Non-retail packaging
IR ACCESSORIES
PWR2 200mA, 12 VOLT DC
REGULATED POWER SUPPLY
For larger distributed IR systems,this regulated
2.1 amp power supply will handle up to ten IRD4s
and all the sensors and emitters connected to
them. Full-color retail box is standard.
PWR3DC REGULATED
POWER SUPPLY
Note:The IRIC IR Interconnect Cable can not be
used w/the IRD4 Amplified IR Distribution Block.
For connecting the IRD4 to any ELAN IR output,
use the 3.5 mm quad-to-mono interconnect cable
incl. with the IRD4.
For use with the IRD4 Amplified IR Distribution
Block, this regulated 200mA power supply is
capable of powering the IRD4 and all the sensors
and emitters connected to it. Full-color retail box
is standard.
ORDER NO. IRIC
ORDER NO. IRYC
ORDER NO. PWR2
ORDER NO. PWR3
(see pg 94 for Power Supply specifications)