User manual

Preset Controls and Displays
l PRESETS A AND B
There are 12 PRESET A faders which
control individual channels 1 -12.
There are 12 PRESET B faders which
control individual channels 1 -12 or
channels 13 - 24 if WIDE is active.
l CHANNEL FLASH BUTTONS
There are 24 CHANNEL FLASH buttons
corresponding to the 12 PRESET A and
12 PRESET B faders. These are used to
flash individual channels. These buttons
can be disabled using the FLASH
ON/OFF button.
l A MASTER AND B MASTER
In two preset operation, the A MASTER is
used to control the maximum output level
from the PRESET A faders. The B
MASTER is used to control the maximum
output level from the PRESET B faders.
In WIDE operation, the A MASTER and
B MASTER faders are used to control the
maximum output level from both the
PRESET A and PRESET B faders, and
the stored scene.
The B MASTER fader is reversed (100%
at the bottom of its travel) to facilitate
manual crossfades when moving the A
MASTER and B MASTER in tandem.
l CROSSFADE
The CROSSFADE control is used to
determine the fade time when crossfading
between scenes. The control can be set
to Manual or to a time between 1 second
and 5 minutes.
l FADING LIGHT
The red FADING light below the
CROSSFADE control flashes when a
timed crossfade is taking place.
l PRESET CONTROL
The PRESET CONTROL button is only
applicable when WIDE is active. This
button is used to control which master
(A MASTER or B MASTER) has control of
the PRESET faders, and which master
has control of the stored scene. The
accompanying lights on the front panel
indicate the current state (A FADERS,
B STORED or B FADERS, A STORED).
Page 10 ELARA 7371000 25.9.98
Preset Mode