User manual

Programming Controls and
Displays
The following controls and displays are
used in PROGRAM Mode.
l PRESET A AND PRESET B
There are 12 PRESET A faders which
control individual channels 1 - 12.
There are 12 PRESET B faders which
control individual channels 1 - 12, or
channels 13 - 24 if WIDE is active.
l CHANNEL FLASH BUTTONS
The 24 CHANNEL FLASH buttons located
below the 12 PRESET A and 12
PRESET B faders are used as memory
selection buttons in PROGRAM Mode.
l A MASTER
The A MASTER fader is used to control
the maximum output level from the
PRESET A faders. If WIDE is active, the
A MASTER is used to control the
maximum output level from both the
PRESET A and PRESET B faders.
l B MASTER
The B MASTER fader is used to control
the maximum output level from the
PRESET B faders. If WIDE is active, the
B MASTER has no effect.
l PREVIEW/EDIT
When EDIT is active, the user can edit
individual channels of a previously
programmed SCENE memory, or the
memory numbers in a SEQUENCE. The
light in the button is illuminated when
EDIT is active.
l MEMORY TYPE
This button is used to select whether a
SCENE memory or SEQUENCE is being
programmed. The red lights above the
button indicate which is currently selected.
l DISPLAY
The DISPLAY indicates the current step
number when a sequence is being
programmed or edited.
l SEQUENCE 1, SEQUENCE 2,
SEQUENCE 3 BUTTONS
These buttons are used to select a
sequence to program/edit. Only one
sequence can be selected/active at a
time. The red light in the button is
illuminated when the sequence is
selected/active.
l CLEAR
The CLEAR button is used to clear a
scene memory or sequence (ie remove
the programmed data and return to an
unprogrammed state).It is also used to
delete a step from a sequence.
l STEP + and STEP -
These buttons are used to select the
required step when inserting, deleting or
editing steps in a sequence.
l PROGRAM
The PROGRAM button is used to save
the output levels into the current scene
memory.
Page 20 ELARA 7371000 25.9.98
Program Mode