User manual

Setting up the Desk for
Programming
1. If the desk is in PRESET Mode or
SUPER USER Mode, press and hold
the MODE button for 1 second to
enter PROGRAM Mode. If the desk is
in RUN Mode, simply press the
MODE button to enter PROGRAM
Mode. The red lights above the
MODE button indicate the current
operating mode.
2. Ensure that DBO is not active
(the light in the DBO button is off)
3. Select WIDE, if required.
4. Set all the PRESET faders to zero.
5. Set the A MASTER, B MASTER and
GRAND MASTER to full.
Selecting a Scene Memory
1. If not already selected, press the
MEMORY TYPE button to select
SCENE.
2. Use the MEMORY PAGE button to
select the required page. The
CHANNEL FLASH buttons below the
PRESET A faders now represent
memories 1 -12; the CHANNEL
FLASH buttons below the PRESET B
faders represent memories 13 - 24.
The yellow lights are illuminated in
the CHANNEL FLASH buttons if the
corresponding memory is
programmed.
3. Press a CHANNEL FLASH button to
select the corresponding memory.
The light in the button flashes to
indicate that the memory has been
selected. The lights in all the other
CHANNEL FLASH buttons go out.
The output levels are determined by
the current positions of the PRESET
faders.
Programming a Scene Memory
1. Select a scene memory to be
programmed as described above.
2. Use the PRESET A and/or the
PRESET B faders to set the required
output levels. The outputs appear
live.
3. Press the PROGRAM button. The
output levels are stored in the
selected memory. The yellow light in
the CHANNEL FLASH button
changes from flashing to on, to show
that the memory is now programmed.
The lights in the other CHANNEL
FLASH buttons come back on if the
corresponding memories are
programmed.
Page 22 ELARA 7371000 25.9.98
Program Mode