User manual

ELARA 7371000 25.9.98 Page 29
In RUN Mode the user can output a single
programmed memory or a combination of
memories. The memories are accessed
using the MEMORY PAGE button, and
the 24 PRESET Faders which are used
as submasters. The current memory page
is indicated by the lights next to the
MEMORY PAGE button. The PRESET A
faders control memories 1 -12, and the
PRESET B faders control memories 13
-24. The lights in the CHANNEL FLASH
buttons are illuminated if the
corresponding memory is programmed.
Any programmed sequences can also be
output, using the SEQUENCE buttons.
Only one sequence can be active at a
time. The output levels, crossfade time,
sequence speed and attack can be
adjusted using the various front panel
controls.
The final output levels of a scene memory
are determined by the programmed levels
in the memory, the appropriate PRESET
fader (submaster) and the GRAND
MASTER.
The final output levels of a sequence are
determined by the programmed levels in
the memory referenced by the current
step, the SEQUENCE MASTER and the
GRAND MASTER.
The desk outputs 24 channels of DMX all
the time. If WIDE is not active, channels
13 - 24 are output at zero.