User manual

Run Mode Controls and Displays
l PRESET A AND PRESET B
The 12 PRESET A faders are used as
submasters to control the output levels of
memories 1 - 12 from the selected
memory page.
The 12 PRESET B faders are used as
submasters to control the output levels of
memories 13 - 24 from the selected
memory page.
l CHANNEL FLASH BUTTONS
The CHANNEL FLASH buttons are used
to flash the associated memories. These
buttons can be disabled using the FLASH
ON/OFF button.
l SEQUENCE MASTER
The SEQUENCE MASTER fader is used
to control the maximum output level of the
selected sequence.
l SPEED CONTROL
The SPEED control is used to regulate
the speed of a sequence being output
The control has a switch position at the
minimum end of its rotation which stops
automatic stepping through a sequence
and gives full manual control.
l CROSSFADE
The CROSSFADE control is used to
determine the fading between steps of a
sequence.
l DISPLAY
When a sequence is active the display will
show the current step being output. If no
sequence is active the display will be
blank.
l SEQUENCE 1, SEQUENCE 2,
SEQUENCE 3 BUTTONS
These buttons are used to select/deselect
a sequence to output. The red light in the
button is illuminated when the sequence
is selected. Only one sequence can be
selected at a time.
l STEP + and STEP -
If a sequence is currently being output,
these buttons are used to move through
the steps of the sequence.
l DIRECTION
This button is used to select the direction
that a sequence will run when it is output.
The accompanying lights indicate which
direction has been selected.
l SOUND
This button is used to activate the audio
input into the desk. The audio input is
used to advance sequences. When the
SOUND function is active the light in the
button is illuminated.
l MEMORY PAGE
This button is used to select the current
memory page. The lights above the
button indicate the selected page.
Page 30 ELARA 7371000 25.9.98
Run Mode