User manual

Entering Run Mode
1. If the desk is in PRESET Mode or
SUPER USER Mode, press and hold
the MODE button for 1 second to
enter PROGRAM Mode. When the
desk is in PROGRAM Mode, press
the MODE button to enter RUN
Mode.
2. Ensure that DBO is not active.
3. Select WIDE, if required.
4. Set all the PRESET faders to zero.
5. Set the SEQUENCE MASTER and
GRAND MASTER to full.
6. Set the CROSSFADE control to
Manual.
Outputting Scene Memories
The programmed scene memories can be
output using the corresponding PRESET
faders.
1. Select the required memory page
using the MEMORY PAGE button.
2. Move the appropriate PRESET fader
to the level required. The
corresponding scene memory is
output.
Page 32 ELARA 7371000 25.9.98
Run Mode