User manual

Setting Recovery Mode
Recovery mode determines the state that
the desk starts in when it is switched on.
If Recovery Mode is On - the desk will
start in the mode that it was in when it
was switched off, except if it was in
SUPER USER Mode, in which case it will
start in PROGRAM mode.
If Recovery Mode is Off - the desk will
start in the Default State.
Press the WIDE button to toggle the
Recovery state. The light in the WIDE
button indicates the recovery state
(on = Recovery On, off = Recovery Off).
Clear All Memories
Press and hold the CLEAR button for 1
second to clear all the programmed
memories. When the memories have
been cleared, the DISPLAY goes blank,
and then returns to displaying the
software version.
Saving Memory Data
1. Ensure a memory module is
connected to the D type socket on the
rear panel of the desk.
2. Press the PROGRAM (SAVE) button.
The programmed memory data is
saved onto the memory
device. OVERWRITING ANY
EXISTING DATA . If the operation is
successful, the DISPLAY flashes
“00”, if not the DISPLAY flashes an
error code. The display then returns
to showing the software version.
Loading Memory Data
1. Ensure a memory module is
connected to the D type socket on the
rear panel of the desk.
2. Press the FLASH ON/OFF (LOAD)
button. The memory data in the
memory device is loaded into the
desk. OVERWRITING ANY
EXISTING DATA If the operation is
successful, the DISPLAY flashes
“00”, if not the DISPLAY flashes an
error code. The display then returns
to showing the software version.
Memory Module Error Codes
Code Error
Errors Saving
01 No module connected
02 Faulty module
Error Loading
03 No module connected
04 Faulty module
05 Wrong desk type
06 Incompatible version
Page 38 ELARA 7371000 25.9.98
Super User Mode