User`s guide

VBN gateway and Network Services System switch configuration 5-5
Software Release 2.30 YesWare Applications User’s Guide 08-01016-01
Procedure 5-1 (continued)
Provisioning the VBN gateway and Network Services System switch
Step Action
9 In the Ethernet Switch and Port Provisioning section, select Add/Search
Switch Information.
10 Select the switch address corresponding to ETH 1, and click the edit
link or
the Search button to launch the Switch Configuration dialog.
11 In the Switch Configuration dialog, provision the ETH 1 IP address as the
"Network Services System" switch. An example configuration is shown in
Figure 5-4. Note the following about the Network Services System switch
configuration:
• The Network Services System has no "Parent" switch and no "Installed
High Speed Ports."
• The "Gateway Address" of the Network Services System is identical to
the "IP address."
• The "Enabled" field must be set to "true" for the switch to function.
Table 5-1 on page 5-6 contains the recommended settings for the Network
Services System in the Switch Configuration dialog.
Figure 5-4
Network Services System example switch configuration
—continued—