User`s guide

EtherLoop system provisioning 6-11
Software Release 2.30 YesWare Applications User’s Guide 08-01016-01
Procedure 6-1 (continued)
Provisioning Enhanced Modem Billing
Step Action
19 Select NSS Maintenance from the YesWare Main Menu to launch the NSS
Maintenance module page.
20 In the System Maintenance section, click Validate the Modem Database
.
The EtherLoop Modem Database Validation dialog should display the
results of the database validation similar to the one shown in Figure 6-15.
Figure 6-9
EtherLoop Modem Database Validation dialog
21 If required, add modem MAC address privacy filters as described in
Procedure 13-1 on page 13-3.
22 Connect a "visitor" PC to as many CPE modem ports as the installation
schedule will allow (at least 10%). Test the system configuration by
attempting to access the Internet/WAN and verifying the following:
• Verify that the appropriate authentication page appears for each
port. That is, ports configured with the credit
Port Use Context display the
credit.vbn page, ports configured with the guest
Port Use Context display
the guest.vbn page, etc.
• Intentionally enter invalid authentication information, and verify
that service is denied. This must be done before successful
authentication, because once authenticated a visitor has access to the
system until the billing period expires.
• After successfully authenticating, verify Internet/WAN access is
successfully granted. That is, the visitor PC is able to access the
Internet.
23 Continue with the YesWare provisioning process in Chapter 8, “YesWare
service billing.”
STOP
You have completed this task.