User`s guide

7-6 Provisioning the Ethernet-VBN switches and ports
Software Release 2.30 YesWare Applications User’s Guide 08-01016-01
Ethernet-VBN switch and port configuration
This section describes the configuration requirements to use the BayStack
303- or Cisco 2900XL-compatible switches in Ethernet-VBN switches as
described in “Ethernet-VBN switch architecture and configuration
requirements” on page 7-2.
Procedure 7-1 on page 7-10 describes the Ethernet-VBN switch and port
configuration procedure.
Switch Configuration dialog
Figure 7-2 shows the Switch Configuration dialog. Table 7-2 on page 7-7
lists and describes the acceptable and required entries for this dialog.
Figure 7-2
Switch Configuration dialog
"Network Services System" switch type configuration
The "Network Services System" switch type is used to configure the YWS ETH 1
interface as a single-port switch serving EtherLoop modems and/or Ethernet-VBN
switches.
See “Provisioning the VBN gateway and Network Services System switch” on page
5-3 for instructions on configuring the Network Services System switch type.