User`s guide

A-6 Remote YesWare Management using SNMP
Software Release 2.30 YesWare Applications User’s Guide 08-01016-01
Table A-4
MIB variables for the EtherLoop Modem System Table
Object Name Description Access Syntax
modemSysCategory The index for the table. Specifies the category
for the data is for CO modems or CPE modems.
read-only INTEGER
coModems
cpeModems
modemSysNumModems The number of modems present for this
category.
read-only Integer32
modemSysNumDownMode
ms
The number of modems, for this category, that
have linkStatus of down.
read-only Integer32
modemSysTrapStatus The status of sending traps for all modems for
this category. If a valid trap destination is not
configured in the SNMP setup, trapsOff is
returned and sets are disabled. Descriptions for
the options are given below.
trapsOff – all traps are off.
modemIdTable – trap status is controlled
individually for each modem and is set in the
modemIdTable.
setAllOn – set trap status for all modems in the
modemId table to trapsOn. Then set this value
to modemIdTable.
setAllOff – set trap status for all modems in the
modemId table to trapsOff. Then set this value
to modemIdTable.
setAllDnTrapsOff – set trap status for all
modems in the modemId table to
modemDownTrapOff. Then set this value to
modemIdTable.
read-write INTEGER
trapsOff
modemIdTable
setAllOn
setAllOff
setAllDnTraps
Off
modemSysAddMacFilter Add a MAC Filter address for all modems in this
category. Enter a space separated MAC
address. e.g., 10 00 F2 00 21 08.
read-write DisplayString
modemSysDelMacFilter Delete a MAC Filter address for all modems in
this category. Enter a space separated MAC
address. e.g., 10 00 F2 00 21 08. To clear all
MAC Filter addresses for all modems, enter the
address 00 00 00 00 00 00.
read-write DisplayString