Integration Manual

CANADA:

This device complies with Industry Canada’s license-exempt RSSs. Operation is subject to the following two conditions:

(1) This device may not cause interference; and

(2) This device must accept any interference, including interference that may cause undesired operation of the device.

Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est

autorisée aux deux conditions suivantes:

1) l’appareil ne doit pas produire de brouillage;

2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre

le fonctionnement.

Special accessories:

Where special accessories such as shielded cables and/or special connectors are required to comply with the emission limits, the

instruction manual shall include appropriate instructions on the first page of the text describing the installation of the device.

Simultaneous transmission:

When the host product supports simultaneous-transmission operations the host manufacturer needs to check if there are additional

RF exposure filing requirements due to the simultaneous transmissions. When additional application filing for RF exposure

compliance demonstration is not required (e. g. the RF module in combination with all simultaneously operating transmitters

complies with the RF

exposure simultaneous transmission SAR test exclusion requirements), the host manufacturer may do his own evaluation without

any filing, using reasonable engineering judgment and testing for confirming compliance with out-of-band, restricted band, and

spurious emission requirements in the simultaneous-transmission operating modes. If additional filing is required please contact the

person at ELATEC GmbH responsible for certification of the RF module.

The end device must be labeled with:

Contains IC ID: 7948A-EINTLEG1