Integration Manual

Laboratory Division

996369 D03 OEM Manual

Guidance for Modular Transmitter

Instruction Manuals and TCB

Certification Application Reviews

Federal Communications Commission

Office of Engineering and Technology

Laboratory Division

996369 D04 Module Integration Guide

Modular Transmitter Integration Guide—

Guidance for Host Product

Manufacturers

Federal Communications Commission

Office of Engineering and Technology

Laboratory Division

For more information about this integration manual or the EINTLEG, go to www.elatec.com or contact ELATEC.

REVISION HISTORY

VERSION

CHANGE DESCRIPTION

EDITION

First edition

11/2020

Second edition

01/2021

Third edition

01/2021

ABOUT EINTLEG

The ELATEC EINTLEG is a module for Bluetooth Low Energy (BLE V5.0). It is equipped with a 2.4 GHz chip antenna, SPI host

interface, configuration inputs and eight GPIOs.

Refer to product data sheet or elatec.com for more technical data.

The following FCC rules are applicable to the modular transmitter:

47 CFR Part 15, §15.247

The modular transmitter requires specific operational use conditions:

Due to RF exposure requirements, the modular transmitter should not be used within 5 mm of the human body (closest separation

between the radiating parts of the device (e.g. antenna) and the user or nearby persons)

FCC ID: WP5EINTLEG1

IC ID: 7948A-EINTLEG1

HVIN: EL20206

INTEGRATION IN OTHER DEVICES

LIMITED MODULE PROCEDURES

The ELATEC EINTLEG provides a Limited Modular Approval Certificate as the module does not have a shielding can over its RF

circuitry and cannot be operated in a stand-alone configuration. The modular transmitter must be integrated into the base board

according to the layout below. Cables of the host may not be located in the area of the modular transmitter.