User's Manual

Elatec GmbH
Page 21 of 44
You are now ready to configure the TWN3 reader.
Please Note:
If the TWN3 reader is plugged into a different USB port of the host computer, this installation
procedure has to be repeated.
6. Transparent Mode
Once a TWN3 device has been turned into transparent mode, a direct link will be established between
the serial interface (V24 or virtual USB), and the reading module. The direct communication with a
transponder reader module is not compatible to each other and requires the knowledge of the specific
communication protocol. Please see the following documents for related information:
TWN3 Type Document
Multi125 T4T5Handbook x.xx.pdf
Mifare TH_Mifare_x.xx.pdf
HID Prox This Document
HID iClass Please contact Elatec GmbH
Legic Please contact Elatec GmbH