TWN4 MultiTech M INTEGRATION MANUAL
TABLE OF CONTENTS INTRODUCTION .............................................................................................................................................................................. 3 ABOUT THIS MANUAL ...............................................................................................................................................................3 SAFETY NOTES ................................................................................................................
INTRODUCTION ABOUT THIS MANUAL This integration manual explains how to integrate ELATEC RFID module TWN4 MultiTech M into a host device and is mainly intended for integrators and host manufacturers. The content of this integration manual is subject to changes and printed versions might be obsolete. As the module manufacturer, ELATEC is responsible for the update, release and publication on the FCC database of this integration manual.
Answers about Modules 996369 D03 OEM Manual 996369 D04 Module Integration Guide Guidance for Modular Transmitter Instruction Manuals and TCB Certification Application Reviews Modular Transmitter Integration Guide— Guidance for Host Product Manufacturers Office of Engineering and Technology Laboratory Division Federal Communications Commission Office of Engineering and Technology Laboratory Division Federal Communications Commission Office of Engineering and Technology Laboratory Division For more informa
Abbildung 1: Dimensions and pinout of TWN4 MultiTech M MECHANICAL INSTALLATION There are 4 holes for mechanical fixation of the board, see Abbildung 1: Dimensions and pinout of TWN4 MultiTech M ELECTRICAL CONNECTION The module can be connected via USB, RS232 and other interfaces see Abbildung 1: Dimensions and pinout of TWN4 MultiTech M The input voltage is 4.3V to 5.5V.
FCC (RF module) Compliance statement: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Host devices FCC notes for a host subject to verification or SDoC: For a host device assembled with the certified module and subject to 47 CFR Part 15 verification of class A digital devices, the following statements have to be included in the user manual and the host device has to be labelled as noted below. If the host device is subject to other authorization procedures or parts the appropriate requirements of these authorization procedures or parts apply.
ELATEC GMBH Zeppelinstr. 1 • 82178 Puchheim • Germany P +49 89 552 9961 0 • F +49 89 552 9961 129 • E-mail: info-rfid@elatec.com elatec.com Elatec reserves the right to change any information or data in this document without prior notice. Elatec declines all responsibility for the use of this product with any other specification but the one mentioned above. Any additional requirement for a specific customer application has to be validated by the customer himself at his own responsibility.