Integration Manual
Table Of Contents
- 1 Introduction
- 2 Safety Information
- 3 Integration instructions
- 3.1 General
- 3.2 List of applicable rules
- 3.3 specific operational use conditions
- 3.4 Limited module procedures
- 3.5 Trace antenna design
- 3.6 RF exposure considerations
- 3.7 AntEnnas
- 3.8 Label and compliance information
- 3.9 test modes and additional testing requirements
- 3.10 Additional testing, Part 15 Subpart B disclaimer
- 3.11 Mechanical installation
- 3.12 Electrical connection
- 3.13 Programmation/Software integration
- 4 Compliance Statements
- 5 Integrator and host requirements
- APPENDIX
© 2021 ELATEC GmbH – TWN4 MultiTech LEGIC M integration manual DocRev2 – 10/2021 Page 3 of 9
1 INTRODUCTION
1.1 ABOUT THIS MANUAL
This integration manual explains how to integrate ELATEC RFID reader module TWN4 MultiTech LEGIC M into a host device and is
mainly intended for integrators and host manufacturers.
The content of this integration manual is subject to changes without prior notice and printed versions might be obsolete. Integrators
and host manufacturers are required to use the latest version of this integration manual.
For the sake of better understanding and readability, this manual might contain exemplary pictures, drawings and other illustrations.
Depending on your product configuration, these pictures might differ from the actual design of your product.
1.2 ABOUT TWN4 MULTITECH LEGIC M
The RFID reader/writer module TWN4 MultiTech LEGIC M is a device for reading and writing RFID transponders. Different versions
of TWN4 devices are available, which cover a large range of transponder types both in the frequency range of 125 kHz and 13.56 MHz.
1.3 ELATEC SUPPORT
In case of any technical questions, refer to the ELATEC website (www.elatec.com) or contact ELATEC technical support at:
support-rfid@elatec.com
1.4 REVISION HISTORY
VERSION
CHANGE DESCRIPTION
EDITION
02
Chapters “Limited module procedures”, “Test modes and additional testing requirements”,
“Compliance statements” and “Integrator and host requirements” updated, chapter
“Additional testing, Part 15 Subpart B disclaimer” added
10/2021
01
First edition
07/2021
2 SAFETY INFORMATION
• ELATEC TWN4 MultiTech LEGIC M is an electronic component and should be installed exclusively by a trained and qualified
personnel.
• ELATEC recommends the integrators to follow general ESD protective measures during the installation of
TWN4 MultiTech LEGIC M into a host device, e.g. the use of an antistatic wristband or special gloves.
• The integrator should not touch the antennas (if not shielded), printed circuit boards, connectors or other sensitive components on
TWN4 MultiTech LEGIC M.
• Before installing TWN4 MultiTech LEGIC M into a host device, the integrator should also make sure that he/she has read and
understood the ELATEC technical documentation related to TWN4 MultiTech LEGIC M, as well as the technical documentation
related to the host device. In particular, the instructions and safety information given in the user manual of
TWN4 MultiTech LEGIC M should be read carefully and listed in the technical documentation of the host manufacturer as well, as
soon as these instructions and safety information are required for a safe and proper use of the host device containing
TWN4 MultiTech LEGIC M.