Integration Manual
Table Of Contents
- 1 Introduction
- 2 Safety Information
- 3 Integration instructions
- 3.1 General
- 3.2 List of applicable rules
- 3.3 specific operational use conditions
- 3.4 Limited module procedures
- 3.5 Trace antenna design
- 3.6 RF exposure considerations
- 3.7 AntEnnas
- 3.8 Label and compliance information
- 3.9 test modes and additional testing requirements
- 3.10 Additional testing, Part 15 Subpart B disclaimer
- 3.11 Mechanical installation
- 3.12 Electrical connection
- 3.13 Programmation/Software integration
- 4 Compliance Statements
- 5 Integrator and host requirements
- APPENDIX
© 2021 ELATEC GmbH – TWN4 MultiTech LEGIC M integration manual DocRev2 – 10/2021 Page 6 of 9
4 COMPLIANCE STATEMENTS
4.1 EU
TWN4 MultiTech LEGIC M is in compliance with the EU directives and regulations as listed in the respective declaration of conformity.
4.2 FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Caution
The Federal Communications Commission (FCC) warns the users that changes or modifications to the unit not expressly approved by
the party responsible for compliance could void the user's authority to operate the equipment.
FCC §15.105 (b)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the Receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC ID: WP5TWN4F19
4.3 IC
This device complies with Industry Canada’s license-exempt RSSs. Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes:
(1) l’appareil ne doit pas produire de brouillage;
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre
le fonctionnement.
IC: 7948A-TWN4F19
4.4 UNITED KINGDOM
TWN4 MultiTech LEGIC M complies with the requirements of the UK legislations and other regulations as listed in the respective UK
declaration of conformity.
The importer is responsible for applying the following information to the packaging of the product:
• UKCA marking
• the importer company’s details, including the company’s name and a contact address in the United Kingdom.