Integration Manual

It is recommended that the host product manufacturer installing the modular transmitter perform some investigative measurements to

confirm that the resulting composite system does not exceed the spurious emissions limits or band edge limits (e.g., where a different

antenna may be causing additional emissions). Detailed information regarding test procedure are described in the relevant rule parts

(refer to Chapter “List of applicable rules”).

3.10 ADDITIONAL TESTING, PART 15 SUBPART B DISCLAIMER

TWN4 MultiTech Nano M is only FCC authorized for the specific rule parts (i.e., FCC transmitter rules) listed on the grant, and the host

product manufacturer is responsible for compliance to any other FCC rules that apply to the host not covered by the modular transmitter

grant of certification. In addition, the final host product still requires Part 15 Subpart B compliance testing with TWN4 MultiTech Nano M

installed.

3.11 MECHANICAL INSTALLATION

TWN4 MultiTech Nano M is available in two different versions: C0 and C1

Version C0 (SMT)

Version C1 (THT)

The version C0 is equipped with solder pads on both sides that enable to integrate (i.e. solder) the module directly onto the PCB or

host device using the SMT technology, whereas the pin connectors on the version C1 are suitable for THT mounting.

For both versions, the components are mounted only on one side of the module to allow an easy integration into the host device.

3.12 ELECTRICAL CONNECTION

3.13 PROGRAMMATION/SOFTWARE INTEGRATION

n/a