Integration Manual
Table Of Contents
- 1 Introduction
- 2 Safety Information
- 3 Integration instructions
- 3.1 General
- 3.2 List of applicable rules
- 3.3 specific operational use conditions
- 3.4 Limited module procedures
- 3.5 Trace antenna design
- 3.6 RF exposure considerations
- 3.7 AntEnnas
- 3.8 Label and compliance information
- 3.9 test modes and additional testing requirements
- 3.10 Additional testing, Part 15 Subpart B disclaimer
- 3.11 Mechanical installation
- 3.12 Electrical connection
- 3.13 Programmation/Software integration
- 4 Compliance Statements
- 5 Integrator and host requirements
- APPENDIX
© 2022 ELATEC GmbH – TWN4 MultiTech 2 LEGIC M LF HF integration manual DocRev1 – 06/2022 Page 4 of 12
3.7 ANTENNAS
The reader module is equipped with the following antennas:
TWN4 MultiTech 2 LEGIC M LF HF
(exemplary picture)
HF antenna (13.56 MHz)
Dimensions: 42 x 47 mm / 1.65 x 1.85 inch
Number of turns: 3
LF antenna (125 kHz)
Diameter: 16 mm / 0.63 inch
Number of turns: 120
For more information, refer to the related product data sheet or
other relevant technical documents.
3
.8 LABEL AND COMPLIANCE INFORMATION
Refer to Chapters “Compliance Statements” and “Integrator and Host Requirements” for detailed label and compliance information.
3.9 TEST MODES AND ADDITIONAL TESTING REQUIREMENTS
No specific testing method has been defined by ELATEC for TWN4 MultiTech 2 LEGIC M LF HF.
TWN4 MultiTech 2 LEGIC M LF HF has been tested and found in compliance with the specifications noted on the approval certificates
and other relevant approval documents. However, the integrator is still responsible for any additional testing and authorization process
required for the end product.
It is recommended that the host product manufacturer installing the modular transmitter perform some investigative measurements to
confirm that the resulting composite system does not exceed the spurious emissions limits or band edge limits (e.g., where a different
antenna may be causing additional emissions). Detailed information regarding test procedure are described in the relevant rule parts
(refer to Chapter “List of applicable rules”).
3.10 ADDITIONAL TESTING, PART 15 SUBPART B DISCLAIMER
TWN4 MultiTech 2 LEGIC M LF HF is only FCC authorized for the specific rule parts (i.e., FCC transmitter rules) listed on the grant,
and the host product manufacturer is responsible for compliance to any other FCC rules that apply to the host not covered by the
modular transmitter grant of certification. In addition, the final host product still requires Part 15 Subpart B compliance testing with
TWN4 MultiTech 2 LEGIC M LF HF installed.
3.11 MECHANICAL INSTALLATION
The module can be fixed with four screws M2.5.