User's Manual

© 2021 ELATEC GmbH – TWN4 MultiTech 3C M user manual DocRev1 – 09/2021 Page 3 of 9
1 INTRODUCTION
1.1 ABOUT THIS MANUAL
This user manual is intended for the user and enables a safe and appropriate handling of the product. It gives a general overview, as
well as important technical data and safety information about the product. Before using the product, the user should read and
understand the content of this user manual.
For the sake of better understanding and readability, this user manual might contain exemplary pictures, drawings and other
illustrations. Depending on your product configuration, these pictures might differ from the actual design of your product.
1.2 ELATEC SUPPORT
In case of any technical questions, refer to the ELATEC website (www.elatec.com) or contact ELATEC technical support at:
[e-mail]
In case of questions regarding your product order or if you wish additional copies of this user manual, contact your Sales representative
or ELATEC customer service at:
[e-mail]
1.3 REVISION HISTORY
VERSION
CHANGE DESCRIPTION
EDITION
01
First edition
09/2021
2 INTENDED USE
TWN4 MultiTech 3C M integrates RFID (125 kHz, 134.2 kHz and 13.56 MHz) and NFC capabilities into a compact but powerful reader.
Its reduced size combined with optimized read/write performance makes it the perfect reader for all applications where small size and
full performance matters, e.g. driver identification. Furthermore, TWN4 MultiTech 3C M provides access to most common host
interfaces, such as USB and CAN, which are readily accessible through an on-board connector.
The product is intended to be integrated into a host device.
Any use other than the intended use described in this section, as well as any failure to observe the safety information listed in this
document, will be considered misuse and will void the warranty. ELATEC is not responsible for any damage or injuries resulting from
any misuse of the product.