User's Manual

Elatec GmbH
Page 10 of 12
Modification of equipment
The instruction manual of the host shall include the following statement:
Changes or modifications made to this equipment not expressly approved
by the party responsible for compliance may void the FCC authorization to
operate this equipment.
Special accessories
Where special accessories such as shielded cables and/or special
connectors are required to comply with the emission limits, the instruction
manual shall include appropriate instructions on the first page of the text
describing the installation of the device.
Final Compliance of end product
The integrator is responsible for the final compliance of the end product
including this certified transmitter module. CFR 47 §15.101 give guidance
in terms of applicable equipment authorization procedures of different end-
products. Typically compliance to subpart 15 B (§15.107 and 15.109) Class
A or B including verification of the subpart 15 C compliance (field strength
of fundamental and out-of-band emissions) of the transmitter parameters
apply.
Simultaneous transmission
When the host product supports simultaneous-transmission operations the
host manufacturer needs to check if there are additional RF exposure filing
requirements due to the simultaneous transmissions. When additional
application filing for RF exposure compliance demonstration is not required
(e. g. if the TWN4 MultiTech 3 module in combination with all
simultaneously operating transmitters complies with the RF exposure
simultaneous transmission SAR test exclusion requirements), the host
manufacturer may do his own evaluation without any filing, using
reasonable engineering judgment and testing for confirming compliance
with out-of-band, restricted band, and spurious emission requirements in
the simultaneous-transmission operating modes.