User Manual

DMX OPERATOR PRO

7.1.2 Setting DMX Address Channels for Dimmer Packs (Par Cans)

The DMX Operator Pro allows for control of up to eight independent dimmer channels via two

channel dimmer packs such as the Elation DP-415 or DP-DMX20L. Dimmer packs can share the

same address and will mimic each others behavior. The eight dimmer channels shall be

controlled via eight independent channel faders. The DMX Operator Pro reserves DMX channels

129 to 136 for the par section. To set two four channel dimmer packs for operation with the DMX

Operator Pro, follow these steps:

(1) Set the starting DMX address channel on your first dimmer pack in the link to (129)- dip

switches 1 & 8 ON.

(2) Set the DMX channel on your second dimmer pack in the link to (133)- dip switches 1,3 &

8 ON.

(3) Additional packs may be linked and assigned to these address settings- 129 or 136. All

packs assigned the same address channels will mimic each other.

7.2 Assign Joystick to Pan & Tilt

(1) Press and hold down the "SETUP" button for three (3) seconds or until the green

LED above the SETUP button comes on. The LCD will display the following with a

cursor box flashing over the # 1 option.

1. CF CARD ↓

2. ASSIGN CH.

(2) Press the "DOWN" button one (1) time so that the cursor is now flashing over the # 2

"ASSIGN CH." option. The LCD will display the following with the cursor box now

flashing over the # 2 option.

1. CF CARD

↓

2. ASSIGN CH.