User Manual

DMX OPERATOR PRO

7.3.2 Record a Moving Light Show (Cont.)

(4) Next, set your desired hold and fade time for your first Show step by using the

“SPEED” fader for your HOLD time and the “FADE” fader for your FADE time. The

hold and fade time range is five tenths of a second to ten minutes. Therefore, the

maximum times that can be set to hold or fade a selected scene step is 10 minutes

and the minimum time is .5 second. Note: When adjusting the speed fader, “S”

represents “Speed” followed by the set hold time- .05 to 59.00S (Seconds), after 59

seconds, the LCD will display “1M00S”, “M” represents minutes and can be adjusted

up to 10M00S (10 minutes and 0 seconds). “F” represents Fade time.

(5) Once your scene is selected and your speed and fade times have been set, press the

“RECORD” button, all of the LED’s will flash one (1) time and your Show step will

advance one (1) time as well. The LCD will display the following:

EDIT SHOW1/TL01

ADD ESC STEP01

• “TL” represents total Show steps and “STEP” represents current Show step. This

becomes important when wanting to edit your Show later (See Editing Moving

Light Shows in section 7.5 on page 18).

(6) Repeat steps 3-5 to continue recording additional steps into your Show. Each time

you record a new scene into your Show, the Show step will advance by one (1). You

can store up to 99 steps maximum per Show.

(7) Once you’ve completed recording your Show, press the “ESC” button two (2) times

to exit record mode.