User Manual

DMX OPERATOR PRO

7.5.1 Add Moving Light Show steps (Cont.)

(6) Press the “RECORD” button one (1) time to store the new scene.

(7) Press the “PAGE” button one (1) time then press the “DOWN” button one (1) time.

(8) Press the “DEL” button one (1) time to erase the temporary step.

(9) To delete additional steps, repeat steps 3 thru 8. Press “ESC” two (2) times to exit.

7.5.2 Delete Moving Light Show steps

(1) Press and hold down the "RECORD" button for three (3) seconds or until the green

LED next to the RECORD button comes ON. The LCD will display the following:

SELECT A SCENE

OR SHOW! PAGE01

(2) Select the “SHOW” button 1-8, that you wish to delete steps out of. The selected

SHOW LED will flash repeatedly. For example, if you select SHOW #1, the LED

above the #1 SHOW button will flash repeatedly and your LCD will display the

following:

EDIT SHOW1/TLXX

ADD ESC STEP00

• TLXX = Total Show steps.

(3) Press the “PAGE” button so that the LED above its button goes OFF. Use the “UP”

and “DOWN” buttons to scroll through your Show steps. Stop at the step that you

wish to delete.

(4) Press the “DEL” button one (1) time. All LED’s on you the Moving Light section of the

console will flash and your Show step will decline by one. The step has been deleted.

To delete additional steps, repeat steps 3 & 4.

(5) Press “ESC” two (2) times to exit.