User Manual

DMX OPERATOR PRO

7.6.1 Record a Par Can Scene (Cont.)

(4) Adjust the “MASTER” fader all the way up to ten (10). The LCD will display the

following:

MSTR255

SAVE ESC PAGE01

(5) Next, use the eight (8) faders, labeled 129-136, to set your desired Par Can scene.

(6) Once your look is set, press the “RECORD” button to SAVE. All LED’s will flash once

confirming that your scene has been saved. Your LCD will once again display the

following:

SELECT A SCENE

OR CHASE! PAGE01

(7) To record additional Scenes, please repeat steps 3 thru 6.

(8) To exit record mode, press the “ESC” button one time.

7.6.2

Record a Par Can Chase

(1) Press and hold down the "RECORD" button for three (3) seconds or until the green

LED next to the RECORD button comes on. The LCD will display the following:

SELECT A SCENE

OR CHASE! PAGE01

(2) Select the “CHASE” button 1-6, where you wish to record to. The selected Chase

LED will flash repeatedly. For example, if you select CHASE #1, the LED above the

#1 CHASE button will flash repeatedly and your LCD will display the following:

EDIT CHASE1/TL00

ADD ESC STEP00