User Manual

DMX OPERATOR PRO
25
7.6.2 Record a Par Can Chase (Cont.)
(3) If you previously programmed Scenes into page #01, the green LED’s above each
button containing a scene, will be ON. At this time, you may select one of those
Scenes or press the “PAGE” button so that the red LED above the Page button
comes ON and then use the “UP” and “DOWN” buttons to scroll through the other
pages. Select the “SCENE” # that you wish to have as your first Chase step by
pressing the corresponding button. The LED above the selected Scene # will then be
flashing. (NOTE: YOU CAN ALSO SET FADERS MANUALLY AND RECORD THEM
INTO A CHASE ON THE FLY. HOWEVER, IF YOU ARE NEW TO DMX OR
PROGRAMMING THIS CONSOLE, IT IS STRONGLY RECOMMENDED THAT YOU
SELECT PRE PROGRAMMED SCENES TO RECORD CHASES).
(4) Once your scene is selected or set, press the “RECORD” button, all of the LED’s will
flash one (1) time and your Chase step will advance one (1) as well. The LCD will
display the following:
EDIT CHASE1/TL01
ADD ESC STEP01
• “TL” represents total Chase steps and “STEP” represents current Chase step.
This becomes important when wanting to edit your Chase later (See Editing Par
Can Chases).
(5) Repeat steps 3-4 to continue recording additional steps into your Chase. Each time
you record a new scene into your Chase, the Chase step will advance by one (1). You
can store up to 99 steps maximum per Chase.
(6) Once you’ve completed recording your Chase, press the “ESC” button two (2) times
to exit record mode.