User Manual

DMX OPERATOR PRO

7.7 Playback Par Can Scenes and Chases

7.7.1 Playback Par Can Scenes

(1) Press the “PAGE” button so the red LED above the Page button comes on.

(2) Locate the page which contains the scene that you wish to playback by using the “UP

& DOWN” buttons. You will notice the Page numbers changing on the top left corner

of the LCD display as you press either the UP or DOWN buttons. (Note: As you are

scrolling through pages, the green Scene LED’s may come on and off. When an LED

is ON, this means that there is a Scene stored there- when the LED is OFF, it means

that the location is empty or has no scene stored there).

(3) Once you’ve located the page containing the scene that you want to playback, press

the desired “SCENE” # 1-6 button. The selected scene LED will begin to flash and

the scene will come ON. The corresponding green LED’s for the channels which are

included into the selected scene will also come ON. (You can manually adjust faders

for channels which were not included into the scene and over ride the output on the fly.

The original scene channels will stay on while the scene is selected.)

(4) To turn the selected scene OFF, press the same scene button or press “STAND BY”.

You may also select another scene in which case the originally selected scene will

turn OFF and the newly selected scene will turn ON and its LED will flash.

(Scenes can also be triggered automatically in sequence. To trigger Scenes automatically

in sequence, select the desired scene page by pressing the “PAGE” button so that the

LED above its button is ON, then use the “UP” AND “DOWN” buttons to scroll through to

desired page. Next, press the “AUTO” button. The Scenes will begin to playback one at a

time according to faders set speed).