User Manual

DMX OPERATOR PRO
27
7.7.2 Playback Par Can Chases
Par Can Chases can be played back in ONE, MIXED or SEQUENCE modes. On the console
MIXED is abbreviated by “MIX” and SEQUENCE by “SEQ”. In ONE mode, Chases playback one
at a time. Each selected Chase will over ride a previously selected Chase. In MIXED mode, all
selected Chase LED’s will flash simultaneously and all selected Chases will run at the same time.
If a channel, 129-136, is included into more than one (1) Chase, the last selected Chase will be
the one to take precedence. In SEQUENCE mode, selected Chases will playback one at a time in
the order they were selected. The relevant Chase LED’s will flash when running while the other
Chase LED’s remain steadily ON in stand by.
(1) Select the desired playback mode by pressing the “One/Mix/SEQ” button. When the
One/Mix/SEQ LED is OFF, you are in “One” mode. When the LED above the
One/Mix/SEQ button is steadily ON, playback will take place in MIXED mode. When
the LED above the One/Mix/SEQ button is flashing, playback will take place in
SEQUENCE mode.
(2) Select the “CHASE” button that you wish to playback. The selected Chase or
Chases will begin to run immediately at the set speed of your “SPEED” fader. At this
time, you may adjust the “SPEED” fader to your desired setting, use the “TAP SYNC”
button by manually tapping on the button two (2) times- the Chase rate will then
change according to the timing between each tap, or press the “FADE+SPEED” to
get a fade effect incorporated into the selected Chase- the fade time can only be
adjusted using the “SPEED” fader which affects both the speed rate and fade time.
(To synchronize your Chase to sound, simply press the “AUDIO” button so the red
LED above the Audio button comes ON. This will disable the FADE effect. Adjust
the “AUDIO” fader to adjust the sensitivity for the internal microphone. The “TAP
SYNC” LED will flash when ever sound is detected.