User Manual

DMX OPERATOR PRO
35
8.4 Channel Patch (Cont.)
(6) Next, press and hold down the "GROUP" button and simultaneously select
the "FIXTURE" number buttons to select the moving lights that you wish to assign
these settings to. All selected moving lights will have the LED above the buttons
flashing.
(7) Now that you’ve patched all desired channels, you need to confirm and save these
settings to memory. To do this, press the "RECORD" button one (1) time. The LCD
display will momentarily read "GOOD". You can now exit menu mode by pressing the
"ESC" button two (2) times.
8.5 Pan / Tilt Fade Set Up
You can set your pan and tilt channels to be the only channels to respond to set fade times.
Selecting “ALL” means, all channels will incorporate all fade times set for a programmed Chase.
Selecting “ONLY” means, only the pan and tilt channels will incorporate the fade times set for a
programmed Chase. The factory setting is “ALL”. If you wish to change this, follow these steps.
(1) Press and hold down the "SETUP" button for three (3) seconds or until the green
LED above the SETUP button comes on. The LCD will display the following with a
cursor box flashing over the # 1 option.
1. CF CARD ↓
2. ASSIGN CH.
(2) Press the "DOWN" button two (2) times so that the cursor is now flashing over the #
3 "P/T FADE ONLY." option. The LCD will display the following with the cursor box
now flashing over the # 3 option.
2. ASSIGN CH.
3. P/T FADE ONLY