user manual

Elation Professional® www.elationlighting.com - Trio-1248 - Page 14
4.3.1 Fade A and Fade B Settings
-The user may set the DMX value for both Fade A and B
1. Push Softkey B to choose and highlight Fade A
2. Adjust StepRate Fader to set the Fade Time for Preset A
3. Push Softkey B a second time to erase the selection
4. Repeat above action to set Fade B using Softkey C
Fade A and Fade B can be chosen simultaneously by using the StepRate Fader to set the same
FaderTime for Preset A and B.
If the user wants to switch into Submaster Mode from another work mode, the console will keep the
current fader settings as the background scene. If the user wants to cancel the current fader set-
tings, simply press the Clear Buffer key to release the fader settings.
4.3.2 Crossfade in Submaster
The user may Crossfade in Submaster Mode. Begin by setting Preset A and B Faders in the
bottom position.
Move the Preset A and B to the top position- the first recorded bump indicator will blink yel
low.
Move the Preset A and B faders toward the bottom position to fade in the first Scene - the
first recorded fade stop blinking as the scene fades in.
Additional Information for Crossfading:
1. To stop a crossfade, move only the Preset A Fader down and then back up. This will fade out the
last output scene.
2. Changing the Work mode will also stop the crossfade immediately and take out the last fade.
3. Any empty Submasters, Submasters with effects or Submasters that already have a level will be
ignored. Example: If any of the Submasters are already in the up position (output), the sequential
crossfade will start from the scene immediately after the highest outputting fader (i.e. If fader 1, 3,
and 5 are up, the crossfade will start from scene 6.)
4. The LCD will show the fader percentage values for both the fade in and fade out as the fade is
occurring.
TRIO-1248 OPERATION - SUBMASTER MODE