Specifications

Design LED 36MH™
©Elation Professional® 27
Design LED 36MH™
VER (Version) - Displays the software version.
RDMX
– This function allows the DMX address to remotely be adjusted from a DMX
console. This setting requires special settings for both the controller and the fixture.
RDMX is on by default. Follow the procedure listed below to access the RDMX functions:
Fixture Settings:
1. Access the main menu.
2. Tap the UP button until “SPEC” is displayed, press ENTER.
3. Tap the UP button until “RDMX” is displayed, press ENTER.
4. The display will show “ON/OFF.”
5. Press the UP button to display “ON” to activate this function, or “OFF” to
deactivate this function.
6. Press ENTER to confirm.
7. Press MODE/ESC to return to the main menu.
Controller Settings:
1. Set the DMX value of channel 1 to a value of 7.
2. Set the DMX value of channel 2 to a value of 7 or 8. When channel 2 is set to "7"
you can adjust the starting address between 1 and 255. When set to "8" you can
adjust the starting address between 256 and 511.
3. Use channel 3 to set your desired DMX starting address. For example: If you
want to set the starting address to 57, set channel 1 to a value of “7,” set channel 2
to a value of “7” and use channel 3 to set your address to 57 by selecting a channel
value of 57. Example 2: If you want to set the starting address to 420, set channel
1 to a value of “7,” channel 2 to "8" and channel 3 to "164" (256+164=420).
4. Wait for approximately 20 seconds for the unit to complete the address
reset function.
DFSE
- With this function you can restore the factory default settings of the fixture. All