LIGHT COPILOT III User Instructions (Rev 1.0 24-004-1264) E-mail: info@ elationlighting.com Internet: http://www.elationlighting.
1 General Introduction Thank you for your purchase of our product LIGHT COPILOT II. This is a high-performance lighting controller with many useful functions. 8 Channels output and 16 Channels output are available for your application. AUDIO and CHASE control are available by this unit. A built-in microphone is provided for easy audio control. The “LATCH” function can override the chase function to remain an individual channel “on”, while the other maintain their chase sequence normally.
7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18. 19. 20. 21. SPEED adjuster upon CH5-8 / CH13-16: To control the Chase speed for 5-8 channels and 13-16 channels. Chase speed adjustment for 13-16 channels can be available under the 16 channels output mode only. User can get higher (lower) speed levels by adjusting the knob towards “Max” ( “Min”). CH1-8 / CH1-16 selector: To select 8 channels output or 16 channels output as the user’s desire.
2.1.2 Rear panel PIN 1 2 3 4 5 6 7 8 9 PIN 1 2 3 4 5 6 7 8 9 CH VCC 12 11 10 9 16 15 14 13 CH VCC 4 3 2 1 8 7 6 5 CONTROL OUTPUT 9 - 16 1 1. 2. 3. 4. 5. 6. 2.2 CONTROL OUTPUT 1 - 8 DC INPUT: 9-12VDC,500mA FOG MACHINE 3 2 AUDIO IN STROBE OUTPUT 4 5 MADE IN PRC 6 CH9-16 outlet: to output signals according to 9-16 channels. CH1-8 outlet: to output signals according to 1-8 channels. Fog machine connector: connects with a fog machine.
. 3 Channel Selector: Moving to the left gets channel 1-4 output, moving to the right gets channel 5-8 output. Operation Guide 3.1 Channel output and controlling functions 3.1.1 8 channels / 16 channels output control: • 8 channels output and 16 channels output are available for the user’s application. • Switch the CH1-8/CH1-16 selector to “CH1-8” position, then 8-channel output function will be available.
• The signal output for Switch Pack can be controlled by STAND BY button. When the STAND BY LED blinks, that means the relevant signal output is disabled. Press the STAND BY button again (relevant LED “off”) to reactivate the signal output. 3.2 External strobes control External strobes can be controlled in the following different flash speed modes. • Switch the “FLASH SPEED selector” to AUDIO mode, the strobes will go sensitively following the audio signals.