Operating instructions

8
3
2
1
Never run the dishwasher without the filters in place.
Filter assembly
For best performance and results, the filter assembly must be cleaned.
The filter efficiently removes food particles from the wash water, allowing it to be
recirculated during the cycle. For this reason, it is a good idea to remove the larger
food particles trapped in the filter after each wash cycle by rinsing the semicircular
filter and cup under running water. To remove the filter assembly, pull on the cup
handle in theupward direction. Theentire filter assembly should be cleaned
once a week.
To clean the coarse filter and the fine filter, use a cleaning brush. Then, reassemble
the filter parts as shown inthe figures left and reinsert the entire assembly in the
dishwasher, positioning in its seat and pressing downward.
The dishwasher must never be used without the filters. Improper replacement of the
filter may reduce the performance level of the appliance and damage dishes and utensils.
If your dishwasher is left in an unheated place during the winter, ask a service technician to:
Cut off electrical power to the dishwasher.
Turn off the water supply and disconnect the water
inlet pipe from the water valve.
Drain water from the inlet and water valve.pipe
(Use a pan to catch the water.)
Reconnect the water inlet to the
water valve.
pipe
Remove the filter in the tub the bottom
anduseaspongetosoakupwater
in sump.
5
4
3
2
1
It is necessary to clean the spray arms regularly for hard water chemicals will clog the
spray arm jets and bearings. To remove the spray arm, screw off the nut to takeoutthe
washer on top of the spray arm and remove the arm. Wash the arms in soapy and warm
water and use a soft brush to clean the jets. Replace them after rinsing them thoroughly.
Main filter
Food and soil particles trapped by this filter are pulverized by a special jet on the
lower spray arm and washed down the drain.
Coarse filter
Larger items, such as pieces of bone or glass, that could clog the drain are
trapped in the coarse filter. To remove an item caught in this filter, gentlysquee
ze the taps on the top of this filter and lift it out.
Fine filter
This filter holds soil and food residue in the sump area and prevents it from
being redeposit on the dishes during a cycle.
- Inspect the filters for obstructions every time the dishwasher has been used.
- By unscrewing the coarse filter.you can remove the filter system.Remove any food remnants and clean the
filters under running water.
2
3
1
2
3
step１：contrarotate the C ,
and then lift it up;
oarse filter step２：lift the Main filter up
step 3： lift the Fine filter up
If do it from step1 to step 3, the filter system will be removed; while if do it from step3 to step 1, the filter system
will be installed.
NOTE：
1
The filter system consists of a coarse filter,a flat (Main filter) And a microfilter
(Fine filter).
The filter prevent larger remnants of food or other objects from getting inside the pump. This residue can
occasionally clog up the filters.