Product data

GAS INSTALLATION REQUIREMENTS

Important !

• The walls adjacent to the cooker must be of heat-resistant material.

• Before installation, make sure that the local distribution conditions (gas type

and pressure) and the adjustment of this appliance are compatible. The applian-

ce adjustment conditions are given on the plate or the label.

• Thisappliancemustbeinstalledandservicedonlybyasuitablyqualied,regi-

stered installer. The installer shall refer to the local standards in force.

• Failure to install the appliance correctly could invalidate any manufacturer’s

warranty.

This appliance is supplied for use on Natural gas, LPG or Town Gas (check the gas regu-

lation label attached on the appliance).

• Appliances supplied for use on Natural gas: they are adjusted for this gas only and

cannot be used on any other gas (LPG or Town gas) without modication.

 The appliances are manufactured for conversion to LPG and Town gas.

• Appliances supplied for use on LPG: they are adjusted for this gas only and cannot be

used on any other gas (Natural or Town gas) without modication.

 The appliances are manufactured for conversion to Natural and Town gas.

• Appliances supplied for use on Town gas: they are adjusted for this gas only and can-

not be used on any other gas (Natural gas or LPG) without modication.

 The appliances are manufactured for conversion to Natural gas and LPG.

If the Natural gas/LPG/Town gas conversion kit is not supplied with the appliance this kit

can be purchased by contacting the After-Sales Service.

CONNECTING THE APPLIANCE TO THE GAS SUPPLY

The gas connection must be carried out by an authorised person according to the relevant

standards.

Ensure that the room in which the cooker is to be installed is adequately ventilated, in com-

pliance with applicable regulations.

• Connect the cooker to the gas mains utilizing rigid or exible pipes.

• The gas supply is connected at the rear of the cooker to the terminal of the gas inlet

pipe (Fig. 7.1).

 The connection pipe must not cross the rear of the appliance.

GAS SECTION