Product data

okok

THE PIPE DOES NOT CROSS THE REAR PANEL OF THE COOKER.

IN CASE OF CROSSING THE BACK PANEL, ENSURE THE PIPE IS POSITIONED

CLOSE TO THE BOTTOM PART OF THE APPLIANCE.

Fig. 7.1

POSSIBLE GAS CONNECTIONS

GAS CONNECTION WITH A RUBBER HOSE

Important!

A rubber hose connection shall only be made if permitted by the applicable local

regulations.

The gas connection is made up of:

• the terminal tting of the inlet pipe;

• the brass connector;

• sealing washer/s;

• the appropriate hose holder (for Natural/Town gas or LPG).

Important!

Ifthebrassconnectorisnotalreadyttedontheappliance(butsuppliedinasepa-

rate kit), screw that connector to the terminal of the gas inlet pipe before starting the

connection to the gas supply.

Use two spanners when connecting the brass connector.

Connecting the cooker to Natural or Town gas

1. If not already tted, t the Natural/Town gas hose holder on the inlet pipe, making sure

that you place the sealing washer between them (as shown in Fig. 7.2).

2. Connect the cooker to the gas supply using a suitable rubber hose (internal diameter

13 mm).

 The hose must comply with the applicable local regulations and be of the correct con-

struction for the type of gas being used.