Product data

3. Make sure that the hose is tightly and securely tted at both ends.

4. Use a standard hose clamp (not supplied) to fasten the hose.

Connecting the cooker to LPG

1. If not already tted, t the LPG hose holder on the inlet pipe, making sure that you

place the sealing washer between them (as shown in Fig. 7.2).

 Important! The LPG hose holder is composed by Natural/Town gas hose hol-

der with LPG hose adapter screwed at the bottom end (interposing the proper

sealing washer between them).

2. Connect the cooker to the gas supply using a suitable rubber hose (internal diameter

8 mm).

 The hose must comply with the applicable local regulations and be of the correct con-

struction for the type of gas being used.

3. Make sure that the hose is tightly and securely tted at both ends.

4. Use a standard hose clamp (not supplied) to fasten the hose.

5. Install a gas pressure regulator.

Important!

To comply with applicable local regulations, a gas pressure regulator (conforming

to the local regulations in force) must be installed when connecting the cooker to an

LPG cylinder.

When connecting the cooker to the gas supply with a rubber hose, make sure that

• the hose is as short as possible, without twists or kinks.

• the hose is not longer than 750 mm (or refer to applicable local regulations) and does

not come into contact with sharp edges, corners or moving parts. Use a single rubber

hose only; never connect the appliance with more than one rubber hose.

• the hose is not under tension, twisted, kinked, or too tightly bent, neither while the

appliance is in use nor while it is being connected or disconnected.

• the hose does not come into contact with any part of the cooker with a surface tempe-

rature of 70°C or above (or refer to applicable local regulations).

• the hose is not subject to excessive heat by direct exposure to ue products or by

contact with hot surfaces.

• the hose can easily be inspected along its entire length to check its condition.

• the hose is replaced at the printed due date or if it shows signs of wear or damage, and

replaced regardless of its condition after a maximum of three years.

• you inform the customer that the gas cylinder valve or the gas supply valve immedia-

tely by the cooker should be closed when the cooker is not in use.

• you inform the customer that the hose should not be subjected to corrosion by acidic

cleaning agents.

After connecting the cooker to the gas supply, make sure that you

• check that the connections are correctly sealed using a soapy solution, but never a

naked ame.

• check whether the injectors are correct for the type of gas being used. If not, follow the

instructions under “GAS MAINTENANCE”.

• replace the sealing washer/s on the slightest sign of deformation or imperfection. The

sealing washer/s is/are the part/s which guarantees a good seal in the gas connection.

• use two spanners when tting the parts (Fig. 7.2).