Operator's Manual

OM-E 2072-09689-00
4-17
To start CCIR programming:
1. Press MENU to display the Menu screen.
MENU
FREQCHAN
CCIR
BIT
2. Press MORE to scroll to the second Menu screen.
MENU
PROGLOCK PSW
DIM
3. Press PROG.
PROG
CCIRRAD
4. Press CCIR to enter the CCIR Programming menu.
5. Press MORE as required to access additional CCIR programming
parameters.
CCIR
PROGRAMMING
DIRSELF
OPT
AMD
In the CCIR Programming mode, you can program the following features:
Option Description See Page …
•
••
• SELF
Configuration of the local (self) station address. 4-20
•
••
• DIR
Directory: configuration of the CCIR address list. 4-21
•
••
• AMD
Messages: preparation of AMD messages ready to be sent with CCIR
calls.
NOTE
During CCIR operation, you can also edit, or prepare, a
message, on-line, using the PAGE EDIT option.
4-22
•
••
• OPT
Options: configuration of the various CCIR options. 4-22
•
••
• STOR
Store the changes made in the CCIR programming session. 4-23
The following sections explain the programming of these features.
4-6. CONFIGURING CCIR SELF-ADDRESSES
4-6.1 CCIR Addressing Plan
CCIR uses selective calling: any station operating on the same channel, or scanning channels in the
same (or partially overlapping) group of channels, will accept a call only if it is directed to it, or to the
set of stations matching the destination specified by the transmitting station.
The current CCIR addressing plan supports six-digit addresses, that is, 000000 to 999999. Previous
CCIR standards specified only four-digit addresses, that is, 0000 to 9999, and therefore, for backward
compatibility, Micom-Z supports both addressing plans. This means that you can program two
independent self-addresses for your radio set, a four-digit self-address and a six-digit self-address, and
the radio will respond to calls using either address.