Operator's Manual

OM-E 2072-09689-00

2-13

Bandwidth set to: Service type: Filter changes after:

HS Data First data PTT

2.7 kHz Voice First microphone or voice PTT

3.0 kHz Data First data PTT

3.3 kHz High speed data First data PTT

CW Morse First CW PTT

LSM Low speed data First data PTT

NOTE

When the filter bandwidth is set to CW, the following CW filter

bandwidths can be configured in the Programming mode using MENU

> MORE > PROG > RAD > PRMT: 0.25, 0.5 or 0.8 (kHz).

2-6. USING THE CHANNEL MODE

The Channel mode is used to operate on a channel already programmed in the Micom-Z.

The following sections describe how to use the Channel mode.

2-6.1 Selecting the Channel Mode

In general, the Micom-Z automatically enters the Channel mode when turned on, and starts using the

last used channel.

If not, use the Menu screen to select the Channel mode: this is the first item on the menu you see when

you press MENU.

To enter the Channel mode:

1. Press MENU to display the Menu screen.

FREQCHAN

CCIR

BIT

2. Press CHAN.

The last active channel flashes in the display.

CH 1

BAND SQ

DSP

3. Press ENTER to confirm your choice, or select another channel as

explained in the Choosing a Different Channel section (para. 2-

6.3).

CH 1

F 2,000.00

BAND SQ

DSP