Operator's Manual

OM-E 2072-09689-00

2-21

type is DPLX, press ENTER twice to accept both transmission and reception frequencies.

Change the frequency type and the frequency as required (see the To change the current

frequency/frequencies section).

4. If necessary, select the other parameters, using the MORE key and pressing the required

function keys.

5. Press MORE twice, and then press STOR.

2-8. USING THE SCAN MODE

NOTE

The Scan mode is available only when ALE and CCIR are turned off

by selecting NONE on MENU > PROG > RAD > OPTS > SLCL.

In the Scan mode, Micom-Z scans preprogrammed channels. The channels used in the Scan mode are

organized in groups. Up to five scan groups, identified as A to E, may be created using the MRC, each

containing up to 200 channels.

When a guard channel is selected, it is monitored after every other scanned channel.

To enter the Scan mode:

1. Press MENU to display the Menu screen.

2. Press SCAN. The last used group flashes in the display.

FREQCHAN

SCAN

BIT

NOTE

You can use the Scan function only after at least one group has been

downloaded by means of the MRC. If no scan group is stored in the

radio, after selecting Scan you will see NO GROUPS, and then the

display skips to the PROG menu.

3. If you want to use the currently displayed scan group, press ENTER.

Press the function key corresponding to the group you want to choose, and then press ENTER

to confirm your choice.

NOTES

• In the Scan mode, one of the five groups is always selected, and

the other groups (up to four) are displayed above the function keys.

• If the selected group is not yet programmed, the message GRP X

EMPTY appears in the display, where X is the selected group.