Operator's Manual

OM-E 2072-09689-00

2-55

3. Press SEND to transmit the call. An audible reply confirms your

connection.

CALL

236985

CHANSEND

BCN

PAGE

4. After the call ends, press MORE > MORE > MORE > MON to mute the speaker.

2-13.4 Using CCIR Channel Mode (Without Scanning)

This section describes how to receive and transmit calls in the CCIR Channel mode, that is, when

scanning is not used.

NOTE

After you finish a call, you can mute the speaker: press MORE >

MORE > MORE > MON.

2-13.4.1 Receiving Calls in the CCIR Channel Mode

2-13.4.1.1 Receiving Individual, Sub-Group, Group, and All Calls

When your transceiver receives a call, the caller’s address appears in the display.

To receive individual, sub-group, group, and all calls:

1. Press any button (including PTT) to accept the call.

CH 12

F 15,000.00

BAND

DSP

2. If you do not press any button (including PTT) for 60 seconds, the call automatically ends.

3. After the call ends, press MORE > MORE > MORE > MON to mute the speaker.

2-13.4.2 Transmitting Calls in the CCIR Channel Mode

NOTE

Before you transmit calls, you must configure at least one directory.

For more details, see the Configuring CCIR Directory Entries section

in Chapter 4.

2-13.4.2.1 Transmitting a Call on a Specific Channel

To select a specific channel:

1. Access the CCIR menu: MENU > CCIR.

CCIR

CALLSCAN

2. Press CALL to access the Call menu. You will see the last called

station.

If necessary, you can scroll to select another station.

CALL

LAST 621565

CHANSEND

BCN

PAGE

3. Press CHAN to access the Channel menu.

4. Press UP/DOWN keys to select a specific channel.