Operator's Manual

OM-E 2072-09689-00
3-8
3-4. INSTALLATION OF DASH-MOUNT MICOM-Z MODEL ON BASIC TRAY
Figure 3-9 shows a typical installation diagram for a dash-mount Micom-Z radio in vehicles.
NOTES
1. See para. 3-6 for details regarding installation on the cooling tray.
2. When using the FAD1410, refer to its Owner’s Guide for
installation instructions.
Fuse Housing
Extension
Leads
Vehicle
Frame
Ground
ACCESSORY
Connector
VDC IN
Connector
Red
Red
Black
Black
DC Power
Cable
Trunk Compartment
Engine Compartment
Passenger
Compartment
Outside the Car
ATU
ANT
Connector
Grounding Strap
No. 14x3/4”
Self-Tapping Screw
Thoroughly
Clean this Area
3/16” Hole
1/4” Lockwasher
Microphone
12V Battery
Basic Mounting
Tray
GPS Antenna
Connector
GPS
Antenna
(Option)
Whip
Antenna
Ferrite
Grounding
Strap
Antenna
Cable
Figure 3-9. Typical Dash-Mount Micom-Z Installation Diagram (Basic Tray)
Figure 3-10 shows typical locations for the components installed within the vehicle.
The radio is installed on the dashboard of the vehicle inside the passenger compartment. The other
components connect to the power source, the battery, and to the antenna, which enables the radio to
transmit and receive.
When you intend to use the GPS receiver, you must also install the GPS antenna at a suitable location,
as explained in para. 3-3.6.
If the battery is located in the rear section of the vehicle, the power cable extends to the battery
location in the rear.