Specifications

Installation
19
Gas Connection
Connect the oven to the gas line with the proper
type of gas according to Local and National In-
stallation Standards.
SG2136 series ovens are rated at 60,000 BTU/Hr
(17.6 kW) (63 MJ). Each oven has been adjusted
at the factory to operate with the type of gas speci-
fied on the rating plate attached to the left side of
the control panel.
Each oven is supplied with a regulator to maintain
thepropergaspressure.The regul ator is essen-
tial to the proper operation of the oven and
should not be removed or replaced with
another model unless approved by Blodgett.
DO NOT INSTALL AN ADDITIONAL REGULATOR
WHERE THE OVEN CONNECTS TO THE GAS
SUPPLY UNLESS THE SUPPLY EX CEEDS THE
MAXIMUM.
The oven and its individual shutoff valve must be
disconnected from the gas supply piping system
during any pressure testing of that system at test
pressuresinexcessof1/2psig(3.45kPa).
The oven must be isolated from the gas supply
piping system by closing its individual manual
shutoff valve during any pressure testing of the
gas piping system at test pressures equal or less
than 1/2 psig (3. 45kPa).
Setting Equipment for Other Types of Gas
Contact a qualified service agency to convert to
anothertypeofgas.
Type of
Gas
Inlet
Pressure
mbars
Burner
Pressure
mbars
Injector
Diameter
mm
Air
Opening
mm
Pilot
Injector
mm
Standard
Delivery
Value kW (H
S
)
G20 25 8.7 2.45 2x16 2 x 0,63 17,6 Nat. Gas
G25 20 13 2.45 2x16 2 x 0,63 17,6 Nat. Gas
G20/G25 20/25 Totally Inscrewed 2.45* 2x16 2 x 0,63 17,6 Nat. Gas
G
2
0
/
G
2
5
2
0
/
2
5
T
o
t
a
l
l
y
I
n
s
c
r
e
w
e
d
Pressure Regulator
2
.
4
5
2
x
1
6
2
x
0
,
6
3
1
7
,
6
N
a
t
.
G
a
s
G30 30/50 20 2.08 2x16 2 x 0,30 17,6 Butane
G31 30/37/50 25 2.08 2x16 2 x 0,30 17,6 Propane
NOTE: * Use with pre-injector of 3.52 mm.