User's Manual

ENG man BRAVO-FUNK-915 00 BRAVO-FUNK-915 Radio remote control system
- Page 17 -
ENGLISH
7. TROUBLESHOOTING
7.1 TYPE OF TROUBLE
Battery Check
LED SIGNAL
POSSIBLE CAUSE SUGGESTED REMEDY
LED does not switch on BATTERY ABSENT
Check that the battery is present and the battery
contacts are clean.
Green LED ashes rapidly SELF-DIAGNOSIS OK
Press START until the green LED ashed slowly. If this
does not occur, see Par.7.3
Red LED on for 1 second, and
then the transmitter switches off
STOP MUSHROOM
BUTTON PRESSED
Release the STOP mushroom button.
Red LED on for 2 second, and
then the transmitter switches off
IDENTIFICATION CODE
NOT ACQUIRED
Perform the acquisition procedure of the access code
(Par. 4.1).
TX UNIT FAILURE
Contact the ELCA assistance service.
Red LED ashes 2 times and
then the transmitter switches off
ON-OFF COMMAND
ACTIVE
Check that there are no ON/OFF commands active on
the transmitter when switched on.
Red LED ashes 3 times and
then the transmitter switches off
LOW BATTERY
Recharge the batteries (see Chap. 6).
Replace the battery with a charged one.
Red LED ashes 4 times and
then the transmitter switches off
JOYSTICK OUT OF ZERO
Check that there are no joysticks out of zero when
power on is performed.
For any other signals not listed
above
See Paragraph 7.2.
SIGNAL
POSSIBLE CAUSE SUGGESTED REMEDY
Blue STATUS LED on the
receiver ashes quickly
discontinuously.
RADIO INTERFERENCE
Ensure there are no other similar systems or sources of
noise such as radio bridges or transmitters. Switch the
transmitter off and back on again.
/
EXTERNAL ANTENNA
(if tted)
Check for correct position and connection.
SYSTEM
INCORRECTLY
INSTALLED
Check system for proper installation (receiving unit
position, metal obstacles,...).
See Paragraph 2.5.
For any causes other
than those listed above
See Paragraph 7.2.
SYMPTOM
POSSIBLE CAUSE SUGGESTED REMEDY
ONE OR MORE CONTROLS
FAIL TO ACTUATE THE
CORRESPONDING
MOVEMENT.
WRONG WIRING
CONNECTION
Check wiring in the receiving unit (see Paragraph 5.2).
COMMAND
TRANSMISSION FAILED
Contact the ELCA assistance service.
- RADIO CONNECTION FAILURE: After having turned the key on the transmitter to position 1, the radio link does not
activate when pressing Start.
The radio connection is active and working when the green Battery Check LED ashes slowly (1 ash every second).
During regular operation, the red LED ashes instead of the green indicating that the battery is low and there are still 10
minutes of battery life.
In the event of no radio link, perform the SELF-DIAGNOSIS OF THE TRANSMITTER: turn the key switch from position
0 to position 1 without pressing Start, the system performs a self-diagnosis, the outcome of which is given by the signal
of the Battery Check LED as shown in the table below:
Note: The lighting of the red LED is accompanied by an acoustic signal.
- REPEATED RADIO CONNECTION FAILURES:
- OPERATING ERROR: